Surge Protection for the Office

• Reliable

Surge Cord protection unit

The surge cord power conditioner combines both surge/transient suppression and EMI/RFI filtration. The unit may be plugged into a standard socket and is connected to the equipment by means of standard IEC socket outlet/s. This compact and inexpensive plug-in unit has full suppression on all conductors and incorporates powerful filtration circuitry.

Telephone and mains surge protection unit

The protector is used to protect any electronic device connected to the telephone line including fax machines, answering machines, cordless telephones, modems and digital communications on alarm panels. (PHD101)

100 Base T Data surge protection unit.

The 100 Base T data transient suppression units are designed to handle speeds in excess of 100 Mbps fully duplexed. They have an insertion loss of less than 0.5dB. Interconnection is made by means of RJ45 Cat. 5 sockets. The units are available in 19” 1U rack mount panels (24 port) or as a stand alone unit (single port) in an 8 wire configuration.

Telephone surge protection

The telephone line conditioner affords powerful lightning protection to equipment which is connected to telephone lines i.e. fax machines, answering machines, computer modems, handsets etc. This telephone device is simply installed by means of an RJ11 plug and socket. A heavy duty version is also available for areas with very severe lightning activity.  The unit is also supplied in a hard wire format for installation in an alternative position away from the telephone socket outlet.

Access surge Conditioner

The access conditioner is designed to protect data and control lines for automatic gate systems intecoms and alarm systems. The unit will handle data speeds in excess of 20 kbps with insertion losses of less than 0.1dB. For simple installation the unit is fitted with screw type terminal blocks and is available in a ten line configuration. Standard voltages available are 5 to 48Vdc. Other voltages are available on request.

RS232 surge protection Line conditioners

The RS232 line conditioners are used to protect the RS232/V.24 protocol. These compact devices are fitted into a standard gender bender housing with a DB25 or DB9 connector configuration. (Male to equipment, female to line). Reversed genders are also offered as a standard as indicated in the part number listing below.

RF Line surge protection Conditioners

The RFC coax unit is a transient suppression device designed to protect RF transceivers. It can be used for frequencies of up to 1GHz with negligible signal loss. The standard device is supplied fitted with “N” type female connectors. Other connector configurations are available on request. The unit is supplied in a compact housing with a removable gas discharge tube (GDT) for easy inspection/ replacement.

Telephone conditioners / PABX Systems

A full range of surge and lightning protection to interface with Krone Disconnect Modules. Installation is easy and grounding is done via connection to the existing frame. The PHD-104 range of plug-in modules protect the equipment and at the same time remain transparent to data flow, allowing it to operate at maximum speed and bandwidth without signal degradation.  The PABX101 panel combines a power filters to protect the power supply, a 10 way disconnect protector which plugs into a 10 way Krone Disconnect Block to protect the telephone lines and a data network protector to protect the telephone management system.